Basic Fire Whoosh 2

来源: Freesound 前往原页面 查看译文
作者:Niedec
许可:CC0 公众共享许可协议  
描述:The same as my other Fire Whoosh sound, but I used a hipass EQ at the 50hz mark to take out some of the "mud." This is a quick fire sound I made using Qubodup's "Swing 25" Public Domain/CC0 upload on this site. It's a bamboo stick swinging, which I layered and toyed with to get the results here. For those curious, here are the steps. I took the file into Reaper, and slowed the file's playback rate to 31 of the original. I then duplicated the file three times, for a total of 4 tracks. TRACK 1 (lowish gasburner sound): Reverb (drumroom impulse response, a mediumsounding reverb with a slight deadness to it. In free impulse loader Reverberate LE, stretched impulse to 150 and set attack time to 0.218s). EQ (8db bandpass near 200hz, rising back to 0 by the 1K mark. Lowpass applied at 5.8khz). TRACK 2 (lowest of sounds, like a bassy gasburner): Chorus effect. That's it. (Specifically Acon Digital Multiply, a free plugin, set to the "romantic" preset). TRACK 3 (not as low as track 2, but closer to track 2 than 1) Reverb (a large hall impulse response. No adjustments, ie. no increased attack or stretching like for Track 1.) Chorus doubler (free plugin Duet, preset: "basic doubler." Same effect as if I had doubled the track and pitched one up 6 cents.) Chorus (free plugin Acon Digital Multiply, preset: "romantic.") TRACK 4 (most flamethrower, whooshy of tracks.) Reverb (impulse response says "hall medium," but it's a thick, even echo from start to finish. Makes the sound go from its default "whoosh" to a flamethrower noise. Chorus doubler (Duet again, preset: basic doubler) Chorus (Acon Digital Multiply, preset: "romantic.") MASTER BUS: Compressor (TDR Kotelnikov mastering compressor, the free successor to the TDR Feedback Compressor II. Preset: Punchy. THRESH: 20.9, SOFT KNEE: 1.5, RATIO: 2:0:1, ATTACK: 7.0 ms, RELEASE PEAK: 165 ms, RELEASE RMS: 165 ms, MAKEUP: 1.5 db, OUTPUT: 2.0 db. That's it.
标签: flamethrower flame whoosh fire burning flames magic
音频格式flac
声音时长00:04
文件大小359.7 KB
比特率602 kbps
采样率44100 Hz
位深度24 bit
声道立体声
音频蛋下载 推荐

◦  支持一键下载
◦  智能提速线路
◦  队列批量下载
◦  免费跨站下载

  加入任务队列
原站点下载 备用

◦  账户登录下载
◦  普通站点线路
◦  单个文件下载
◦  免费站内下载

  前往声音页面

———— 类似的声音 ————

by 14GPanskaLetko_Dominik
来源Freesound
描述:除臭火焰喷射器。
来源Freesound
描述:攻击性的快速怪物或火焰嗖嗖
Tag: 怪物
by Niedec
来源Freesound
描述:这是我在本网站上使用Qubodup的“Swing 25”Public Domain / CC0上传时发出的快速声音。这是一个摇摆的竹棍,我将其分层并玩弄以获得结果。 对于那些好奇的人,这里是步骤。 我将文件带入Reaper,并将文件的播放速度降低到原来的31%。 然后我复制了三次文件,共计4首曲目。 TRACK 1(低气体燃烧器声音): 混响(鼓室脉冲响应,中等响声混响,轻微死亡。在自由脉冲加载器Reverberate LE,拉伸脉冲达到150%并将攻击时间设置为0.218 S)。 EQ(8db带通在200hz附近,在1K标记处上升到0。低通应用于5.8khz)。 TRACK 2(声音最低,如低音燃气灶): 合唱效果。而已。 (特别是Acon Digital Multiply,一个免费的插件,设置为“浪漫”预设)。 TRACK 3(不低于音轨2,但更接近音轨2而不是1) 混响(大厅冲击响应。无需调整,即没有像音轨1那样增加攻击或拉伸) Chorus doubler(免费插件Duet,预设:“基本倍增器。”效果相同,就好像我将赛道翻了一倍,然后投了6美分。) 合唱(免费插件Acon Digital Multiply,预设:“浪漫。”) TRACK 4(大多数火焰喷射器,嘶哑的曲目。) 混响(脉冲响应说“大厅中等”,但它从头到尾都是一个厚厚的,均匀的回声。使声音从默认的“嗖嗖”变为火焰喷射器噪声。 合唱倍增器(再次Duet,预设:基本倍增器) 合唱(Acon Digital Multiply,预设:“浪漫。”) MASTER BUS: 压缩机(TDR Kotelnikov掌握压缩机,TDR反馈压缩机II的免费继承器。预设:Punchy。THRESH:20.9,SOFT KNEE:1.5,比率:2:0:1,攻击:7.0 ms,RELEASE PEAK:70 ms,RELEASE RMS:165 ms,MAKEUP:1.5 db,OUTPUT:2.0 db。 而已。
by hnhnh
来源Freesound
描述:火嗖嗖。深脂肪迅速火灾增加。 (柴油抛火+俯仰n EQ)
by OfItAll
来源Freesound
描述:一个大型的气体杂草火炬被点燃。包括点击启动器和一个假启动然后几秒钟的燃烧。会产生一个好的火焰投掷声。 录制时间:2014年8月,带有Android Voice Recorder(单声道),下午在户外/后院。
by Nagwense
来源Freesound
描述:小气火:快速燃烧燃气灶火焰。设置在高处引起蓝色火焰。用立体声录制的Zoom H6 Handy录音机录制。
by SGAK
来源Freesound
描述:用立体声话筒录制的小型汽油火。
来源Freesound
描述:这是我用ZOOM R16的板载电容和多个话筒录制的个人文件的声音汇编:257,58,AT2020 ...每个通道都被各种eqing技术和立体声频谱扩展器塑造,最后被压缩。
来源Freesound
描述:这是我用ZOOM R16的板载电容和多个话筒录制的个人文件的声音汇编:257,58,AT2020 ...每个通道都被各种eqing技术和立体声频谱扩展器塑造,最后被压缩。
来源Freesound
描述:这是我用ZOOM R16的板载电容和多个话筒录制的个人文件的声音汇编:257,58,AT2020 ...每个通道都被各种eqing技术和立体声频谱扩展器塑造,最后被压缩。
by Sam_Kaleja
来源Freesound
描述:火。使用SoundDevice和Senheiser麦克风录制。
by las98
来源Freesound
描述:火地岛
by IanLyanx
来源Freesound
描述:点燃火声
by IanLyanx
来源Freesound
描述:火出去了
by IanLyanx
来源Freesound
描述:点燃火声